Induction Shrink fit steel gear

Objective Heat the bore of a hardened spur steel gear to shrink fit onto a gear motor shaft. This is part of a chair for the disabled.
Material Steel gear 2.5″ h (63.5mm) OD, .75″ h (19mm) ID x .625″ h (16mm) thick, temperature indicating paint
Temperature 400 oF (204 oC)
Frequency 30 kHz
Equipment .Power of 15 kW induction heating system, equipped with a remote workhead containing two 0.66 ƒÊF capacitors for a total of 1.32 ƒÊF
. An induction heating coil designed and developed specifically for this application.
Process A four turn helical internal coil is used to heat the gear bore. The coil is inserted into the gear bore and power is applied for 10 seconds to reach the required 400 oF (204 oC) and expand the gear bore. The gear is then placed on the shaft and allowed to cool, creating the shrink fit between the gear and the shaft.
Results/Benefits Induction heating provides:
. No pre-heat cycle, heat is available on demand
. Energy efficient, heats only the part, not the atmosphere around it
. Controlled, even distribution of heating
. Faster production times

shrink fit steel gear