Induction Case Hardening Shaft
Views Send Enquiry
Case hardening shafts
Objective Harden the gear end of an armature shaft to 58-65 Rockwell C at a depth of 0.02″(.51mm) on the center line of the teeth and to 49-55 Rockwell C at a depth of .010″ (.3mm) on the center line of the root.
Material Steel armature shaft measuring 7″ (177.8mm) in length with a gear diameter of approximately 1/2″ (12.7mm).
Temperature 1700ºF(926.7ºC)
Frequency 140 kHz
Equipment •Power of 30kW induction heating system equipped with a remote workhead containing two (2) capacitors
totaling 0.5 μF
• 4-20 mA input simulator
• An induction heating coil designed and developed specifically for this application.
Process A five turn helical coil is used to heat the gear end of the shaft to 1700ºF (926.7ºC) for 2.5 seconds to achieve the desired hardness.
Results/Benefits Induction Heating Provides:
• Pin-point accuracy
• Maximum repeatability
• Faster cycle time
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction hardening axle (shaft) by 100KW induction heater
induction quenching axle (shaft) by 160KW induction heater
induction hardening inner surface (inwall)
Induction Hardening Harvestor Combined Finger
Induction Hardening Harvestor Combined Blade
workpiece for induction hardening
induction hardening veterinary instrument
induction hardening surgical device
Newest Comment
No Comment
Post Comment