Induction Hardening bed knife blade
Views Send Enquiry
Objective Harden a selected area on an 18″(457.2mm) bed knife blade for a reel type lawn mower. The hardness desired is between 45 to 55 Rockwell C, and should be measured 0.062″(1.6mm) from the cutting edge.
Material 1070 Steel Bed Knife Blade measuring 18″(457.2mm) long, 1 17/32”wide (38.9mm) and 0.135″(3.4mm) thick.
Temperature 1550ºF(843.3ºC)
Frequency 108 kHz
Equipment • Power of 45kW induction heating system equipped with a remote workhead containing four (4) capacitors
totaling 1.0 μF
• An induction heating coil designed and developed
specifically for this application.
Process A single turn channel coil with ceramic guides is used to scan along the length of the blade for 30 seconds to reach 1550ºF (843.3ºC). Immediate quenching and rigid fixturing is necessary to prevent blade distortion.
Results/Benefits Induction heating provides:
• Precise & accurate placement of heat
• Consistent and repeatable results
• Non-contact clean heat
Material 1070 Steel Bed Knife Blade measuring 18″(457.2mm) long, 1 17/32”wide (38.9mm) and 0.135″(3.4mm) thick.
Temperature 1550ºF(843.3ºC)
Frequency 108 kHz
Equipment • Power of 45kW induction heating system equipped with a remote workhead containing four (4) capacitors
totaling 1.0 μF
• An induction heating coil designed and developed
specifically for this application.
Process A single turn channel coil with ceramic guides is used to scan along the length of the blade for 30 seconds to reach 1550ºF (843.3ºC). Immediate quenching and rigid fixturing is necessary to prevent blade distortion.
Results/Benefits Induction heating provides:
• Precise & accurate placement of heat
• Consistent and repeatable results
• Non-contact clean heat
Good
Bad
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction hardening axle (shaft) by 100KW induction heater
induction quenching axle (shaft) by 160KW induction heater
induction hardening inner surface (inwall)
Induction Hardening Harvestor Combined Finger
Induction Hardening Harvestor Combined Blade
workpiece for induction hardening
induction hardening veterinary instrument
induction hardening surgical device
Newest Comment
No Comment
Post Comment