Induction Forging Steel Horse Shoes
Views Send Enquiry
Objective To heat a strip of 1025 steel to 1800 oF prior to a forging process for the production of horse shoes.
Presently, blanks are cut and heated in a gas fired oven and then forged in the press.
With an induction coil in place, the steel would be fed continuously from a roll through the induction coil and into the forging press.
In order to meet the increased production rate, heating of the 13" steel section must occur within 10 seconds.
Material 1025 Steel strip approximately 3/4" wide and 1/4" thick.
Temperature 1800 oF
Frequency 15 KHz
Equipment UM-40AB-MF output solid state induction power supply including a heat station with a total capacitance of 0.5 μF.
Process UM-40AB-MF output solid state induction power supply was found to efficiently achieve the following results:
. 1800 oF was reached in 10 seconds.
. The production rate of 1 part every 5-10 seconds was met.
. The above results were achieved through the use of a 39 turn helical style work coil measuring 1 1/2" ID and 11 1/2" OAL.
Related Content
Remove plastic coating from steel tubes by Induction Heating
induction forging
induction heating steel rod by UM-40AB-HF
induction debonding from steel rod
induction heating steel plates by auto feed system with 120KW induction heater
induction melting steel by 40KW power supply with graphite crucible
induction melting steel by custom-design 120KW induction heater
induction quenching head and end part of steel rod (axle)
Hot
induction forging
induction forging steel billets
medium frequency induction forging steel rods (steel bars)
induction forging steel rods (steel bars)
medium frequeny induction forging steel billets with pneumatic feed system
induction forging steel rods_3
induction forging steel rods_2
induction forging steel rods_1
Newest Comment
No Comment
Post Comment