Induction Soldering Steel to Brass
Views Send Enquiry
Objective
Heat an assembly of small, gold-plated steel connectors to a brass block.
Approx. 1/8” (3.2mm) diameter gold-plated steel connectors,
1”(25.4mm) square x 1/4” thick brass block ,600°F(315.6ºC),240 kHz
Temperature,Frequency,Equipment
6 kW induction heating system equipped with aremote workhead.
An induction heating coil designed and developed specifically for this application.
Process
A two-turn helical coil is used to provide uniform heat to parts
assembly. Solder paste and flux are applied to the joint area and power is applied for 20 seconds to solder the parts. Proper fixturing is needed to hold the parts in position.
Good
Bad
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction brass soldering for copper bricks
induction brass soldering stator ends of wind driven generator within 2 seconds
ultra-high frequency induction brass soldering
induction brass solering_2
induction brass solering_1
induction brass soldering_2
induction brass soldering_1
induction brass soldering
Newest Comment
No Comment
Post Comment