Induction Brazing a carbide to a stainless steel shaft
Views Send Enquiry
Objective : Brazing a cone shaped carbide to a stainless steel shaft for a digger
Material : Cone shaped carbide 1.12” (28.4mm) dia, 1.5”(38.1mm) tall,stainless steel shaft 1.12” (28.4mm) dia and various length, black brazing flux and braze shims
Temperature :1500 ºF (815 ºC)
Frequency :227 kHz
Equipment :
• HF 15kW induction heating system, equipped with a remote workhead containing two 1.0μF capacitors for a total of 0.5μF
• An induction heating coil designed and developed specifically for this application.
Process A three turn helical coil is used to braze the carbide to the shaft. Thesteel shaft is fluxed and the braze shim placed on top. The carbide tip is fluxed and placed on top of the shim, lining up the countersunk
hole in the carbide.
The hole is not fluxed because the flux outgases and causes the carbide to build up pressure and attempt to repel from the shaft. Power is applied for 85 seconds for the braze shim to flow and make a good joint.
Results/Benefits
• Rapid localized heating only where needed
• Creates clean, controllable joints
• Hands-free heating that involves no operator skill for manufacturing
Material : Cone shaped carbide 1.12” (28.4mm) dia, 1.5”(38.1mm) tall,stainless steel shaft 1.12” (28.4mm) dia and various length, black brazing flux and braze shims
Temperature :1500 ºF (815 ºC)
Frequency :227 kHz
Equipment :
• HF 15kW induction heating system, equipped with a remote workhead containing two 1.0μF capacitors for a total of 0.5μF
• An induction heating coil designed and developed specifically for this application.
Process A three turn helical coil is used to braze the carbide to the shaft. Thesteel shaft is fluxed and the braze shim placed on top. The carbide tip is fluxed and placed on top of the shim, lining up the countersunk
hole in the carbide.
The hole is not fluxed because the flux outgases and causes the carbide to build up pressure and attempt to repel from the shaft. Power is applied for 85 seconds for the braze shim to flow and make a good joint.
Results/Benefits
• Rapid localized heating only where needed
• Creates clean, controllable joints
• Hands-free heating that involves no operator skill for manufacturing
Induction-Brazing-a-carbide-to-a-stainless-steel-shaft
Good
Bad
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Newest Comment
No Comment
Post Comment