Induction Heating Aluminum Auto Trim
Views Send Enquiry
Objective :To heat various sizes of aluminum auto trim to 500°F (260°C) at a rate of 30 ft. (9.1m) per minute for curing an adhesive.
Material: Magnetic steel and aluminum auto trim parts, coated with adhesive; 1.85” (47mm) ID ceramic tube
Temperature :500 °F (260°C)
Frequency :152 kHz
Equipment
• HF 25kW induction heating system equipped with a remote workhead with six 0.75μF capacitors for a total capacitance of 0.5 μF
• An induction heating coil designed and developed
specifically for this application.
Process :To simulate continuous production, a slide table/stepping motor arrangement and ceramic tube are used to move the parts through the eight turn helical coil at 30 ft. (9.1m) per minute. In continuous production, an infrared sensor can be used to measure the temperature of the aluminum after exiting the coil and adjust output of the power supply to maintain the required 500 °F (260°C).
Results/Benefits:
• Consistent, controllable heat
• Hands free operation
• Reliable, repeatable results
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction heating bolts from turbine
induction debonding from steel rod
induction debonding rubber
Releasing Fixture by Induction Heating
Remove plastic coating from steel tubes by Induction Heating
Induction Heating catheter tipping die
Induction Molding for teflon catheter tip
induction melting for crystal growth
Newest Comment
No Comment
Post Comment