Induction Bonding Steel Clips
Views Send Enquiry
Objective To heat metal clips and press-bond them into rubber seals. The metal needs to be heated to 250°F to 350°F with a cycle time not exceeding 3 seconds
Material Steel clips and rubber sealer blocks
Temperature 250°F to 350°F
Frequency 373 kHz
Equipment Power of 6kW power supply including one remote heat station with one 1.2 μF capacitor using a specially
designed 3-turn pancake coil Process As illustrated below
Results Heating time of 1.5 seconds was attained; shorter heating times are possible due to fast response of the power supply. Bond formation is acceptable due to the even heat pattern produced through induction heating.
Material Steel clips and rubber sealer blocks
Temperature 250°F to 350°F
Frequency 373 kHz
Equipment Power of 6kW power supply including one remote heat station with one 1.2 μF capacitor using a specially
designed 3-turn pancake coil Process As illustrated below
Results Heating time of 1.5 seconds was attained; shorter heating times are possible due to fast response of the power supply. Bond formation is acceptable due to the even heat pattern produced through induction heating.
Good
Bad
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Newest Comment
No Comment
Post Comment