Induction Heating Titanium Blade
Views Send Enquiry
Heating Titanium Blade
Objective Heat a titanium blade to 500°F (200°C) to melt and drain the wax from inside the blade.
Material 4” length (101.6mm) titanium blades with 1.5” x 0.25” (38.1mm x 6.4mm) metering area
Temperature 500°F (200°C)
Frequency 186 kHz
Equipment • Power of 10kW induction heating system equipped with a remote workhead.
• An induction heating coil designed and developed specifically for this application.
Process A specially designed eight-turn helical coil is used to heat to the blades. Power is applied for 3.5 minutes. The wax melts and drips out of the blade.
Results/Benefits Induction heating provides:
• Uniform and repeatable performance
• Faster application time
• Non-contact heating
Heating Titanium Blade
Good
Bad
Related Content
Air Cooled clamp coil (half-open coil) for preheating gas pipeline
induction coating by air cooled clamp induction coil
Remove plastic coating from steel tubes by Induction Heating
Releasing Fixture by Induction Heating
U shape air cooled induction coil by UM-100C-HF for pipeline preheating
induction quenching with custom-design inductor
induction brazing diamond segment
induction brass soldering copper plate_2
Hot
induction heating bolt
induction heating steel rod by UM-40AB-HF
induction heating end of pipeline by 160kw induction heater
induction heating steel plates by auto feed system with 120KW induction heater
induction heating cambered work-piece by 160KW power supply
Induction heating for Plastic Reflow With Catheter Tubing
U shape induction coil for heating hole
induction heating steel rod with double coils
Newest Comment
No Comment
Post Comment