Induction Bonding Rubber to Steel
Views Send Enquiry
Objective To bond rubber gaskets to the top and bottom of a steel gas tank assembly.
Material Flat and round rubber gaskets, steel gas tank assembly
Temperature 300 to 350°F(148.9-176.7°C)
Frequency 183 kHz for the flat gasket; 231 kHz for the round gasket
Equipment •Power of 15kW induction heating system equipped with a remote workhead containing two 1.25 μF capacitors for a total of 0.625 μF
• An induction heating coil designed and developed specifically for this application.
Process Two two-turn pancake coils are specially contoured to the the shape of the steel assembly to produce uniform heat in the gasket areas. The gaskets are positioned over the joint areas.
Power is applied for 6.5 seconds to reach the bonding temperature of 320°F (160°C).
Results/Benefits Induction heating provides:
• Repeatable, rapid & accurate heating cycles
• Reduced process time
• Even distribution of heat
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction painting after induction bending for pipelines
induction heating steel plate
induction remove copper from aluminium
induction heating stator frame
induction heating graphite mould
difference between induction heating inner surface and outside surface of steel ring
induction heating steel pot bottom
induction heating for heat preservation
Newest Comment
No Comment
Post Comment