Induction Brazing Steel to Steel

 Views Send Enquiry

Objective To braze O-ring Face (ORFS) sleeve or male connector to a steel tube.
Material • Steel tube, 1 inch (2.54 cm) OD
• O-ring Face Seal sleeve and a male connector fittings
• Preform braze rings
• White SureFlow flux
• Steel support mandrel
Temperature 1300 ºF (704 ºC)
Frequency 163 kHz
Equipment • Power of 10 kW induction heating system, equipped with a remote workhead containing two (2) 1.5 μF capacitors (for a total of 0.75 μF).
• An induction heating coil designed and developed specifically for this application.
Process A four-turn 2.75 inch (7.0 cm) ID helical coil is used for heating both the steel tube and the ORFS sleeve or the ORFS male connector. This coil is designed to braze either the sleeve or male connector to the tube. The parts to be brazed are assembled with flux and heated for 45 seconds. Pressure is applied to the tube to make sure it is inserted fully into the fittings as the braze ring flows.
Results/Benefits Advantages :
• Large Inner diameter of coil allows for easy loading and unloading of parts
• With efficient energy coupling of the coil to the fittings
overheating is avoided.

brazing-steel-to-steel
brazing-steel-to-steel

PDF: Induction Brazing Steel to Steel

Good
Bad

Newest Comment

    No Comment

Post Comment

Verify Code: