Induction Heat seat springs for powder coat
Views Send Enquiry
Objective Heat the steel spring assemblies of automotive seats to powder coat
Material · Steel wire springs ~24” (61 cm) long, 1/8 “ (3.175mm) diameter cross section
Temperature 500 °F (250 °C)
Frequency 57 kHz
Equipment Power of 70 kW, induction heating system, equipped with a remote heat station containing four 1.0 mF capacitors for a total of 1.0 mF
An induction heating coil designed and developed specifically for this application
Process A multi-turn helical coil is wound in a special cross pattern to heat the bottom 1.5 turns of the steel to be coated. This coil efficiency heats the special geometry of the springs. The springs are heated for 10-15 seconds and then soak for another 10-15 seconds before being dipped in the UIHM powder bath. This insures good even flow of the UIHM.
Results/Benefits · Even heating of the spring before dipping provides uniform flow and provides consistent thickness of the nylon coating
· Higher quality end product vs. using an open flame convection furnace. Ovens are sensitive to ambient
temperature and humidity variations and tend to produce uneven results.
Heat seat springs for powder coat
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction painting after induction bending for pipelines
induction heating steel plate
induction remove copper from aluminium
induction heating stator frame
induction heating graphite mould
difference between induction heating inner surface and outside surface of steel ring
induction heating steel pot bottom
induction heating for heat preservation
Newest Comment
No Comment
Post Comment