Induction Hermetically sealing glass
Views Send Enquiry
Objective Provide a hermetic seal of glass enclosed resistor to a lead
Material Resistor
Kovar rings, 0.1 inch (0.254cm) diameter
Glass tube slightly larger than 0.1 inch (0.254cm) diameter, 0.5 (1.27) inch length
Metal lead
Temperature 900 ºF (482) ºC
Frequency 324 kHz
Equipment • Power of 6kW induction heating system, equipped with a remote workhead containing two (2) 1.5 μF capacitors (for a total of 0.75 μF).
• An induction heating coil designed and developed specifically for this application.
Process A three turn concentrator plate coil is used to heat the Kovar ring for 500 milliseconds. This causes the glass to melt and seal one side of the resistor. The resistor is then turned over and the process is repeated to seal the other side using a second Kovar ring.
Results/Benefits Induction heating provides precise, consistent heat to very
small parts resulting in repeatable, quality seals.
By heating with medium frequency, arcing (which occurs at high frequencies) is avoided.
Hermetically sealing glass
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction brazing SS steel by handheld induction coil
induction brazing shoe mold
induction brazing drill bit of transformer
customized RF induction heater for brazing works
induction brazing stator
water cooled flexible handheld induction coil for heating SS steel pipe
water cooled flexible handheld induction coil for heating SS steel pipes
UHF handheld induction heater for brazing copper
Newest Comment
No Comment
Post Comment