Induction Solder Flex Circuits
Views Send Enquiry
Objective To heat multiple joints on flex circuit strips to 180-200°F within seven seconds for a soldering application.
Material Copper bonded to polyester flex circuit strips, Solder Plus Paste 63NC-A, 0.0625” thick Teflon sheets
Temperature 183°F
Frequency 278 kHz
Equipment Power of 6 kW power supply, remote heat station with one 1.2 μF capacitor and a specially designed induction coil.
Process A specially designed induction coil was used to provide even heat in the area where the fingers of the flex circuits overlap. Initial tests were done to establish a heating pattern and determine time-to-temperature. After a very light coat of the solder paste was applied to the circuit connections, a small amount of pressure was applied to the Teflon sheets to hold the circuits together. RF power was then applied for 6.5 seconds to flow the solder paste and bond the flex circuits
Results Consistent and repeatable results were achieved using the 6kW power supply in 6.5 seconds at 183°F.
Solder Flex Circuits
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction brazing SS steel by handheld induction coil
induction brazing shoe mold
induction brazing drill bit of transformer
customized RF induction heater for brazing works
induction brazing stator
water cooled flexible handheld induction coil for heating SS steel pipe
water cooled flexible handheld induction coil for heating SS steel pipes
UHF handheld induction heater for brazing copper
Newest Comment
No Comment
Post Comment