Intro: Heating brass mandrel die Objective Water-cooled brass mandrel die, nylon LDPE catheter, “K” type thermocouple and temperature controller.Material materials, supplies involved in the applicationTemperature 400F (204C)Frequency 325kHzEquipment Power …

Intro: Heating steel mandrel tip Objective Heat a water-cooled steel mandrel to 700F (371C) to form a high quality Teflon catheter tip.Material Teflon catheter tubing, mandrel assemblyTemperature 600-700F (315-371C)Frequency 376 kHzEquipment • Power of 10kW…

Intro: Heating Catheter Tipping Die Objective: To heat an aluminum catheter tipping die to above 2850F within 2 to 5 seconds for the forming of catheter material. Presently, heating is performed in 15 seconds with older induction equipment. The customer woul…

Intro: Heating fan blades for welding Objective To uniformly heat jet engine turbine fan blades to 1800F (982.2C) within five minutes for a welding applicationMaterial Jet engine turbine fan blades with 2”(50.8mm) length tipTemperature 1800F (982.2C)Frequen…

Intro: Soldering Co-axial Wire Objective To solder center-conductor and shielding braid of wireassemblies to 500 (250) F(C).Material • Customer-supplied assemblies• Temperature indicating paint• Flux-cored solder wireTemperature 500 (250) F (C)Frequency 2…

Intro: Soldering wires onto connector Objective Heat connector assemblies for solderingMaterial Device assemblyTin plated brass terminals Solder pasteTemperature 500F (260C) 5-7 secondsFrequency 360 kHzEquipment Power of 6 kW induction heating system equippe…

Intro: Soldering satellite antennas Objective Soldering steel onto GPS body for phone antennaMaterial Thin copper foil 0.3mm (0.01 in) thick Ceramic body 12mm (0.47 in.) long x 7mm (0.28 in.) wideTemperature 200 C (392 F)Frequency 371 kHzProcess Time 5 secon…

Intro: Soldering brass Objective To solder a brass end cap to a series of copper tubesMaterial Preassembled heat exchanger with copper tubes and 2 brass end caps 2.36” (60mm) OD, 0.08” to 0.12” (2 to 3mm) thick at both ends, liquid solderTemperature 302F …

Intro: Soldering circuit boards Objective To heat post, lead or lead-free solder preforms for various circuit board soldering applications.Material Upper and lower circuit boards, small and large lead or lead free preforms.Temperature < 700 F (371C) depen…

Intro: Soldering brass and copper Objective To heat brass and copper for soldering application on medical equipmentMaterial Brass ring, brass and copper pieces 5.11” (130mm) long, 4.3” (110mm) OD & 0.3” (7mm) at thickest point and solder ringsTemperat…