Objective To separate bonded stainless steel / carbon fiber assemblies by heating tang, softening the adhesive bondMaterial Stainless steel and carbon fiber insertsTemperature 300 F (149C)Frequency 200 kHzEquipment • UM-UHF-6kW induction heating system, e

2007/04/03

Objective Heating end of a stainless steel handle with a plastic sleeve coated with heat adhesive for a bonding applicationMaterial 1” (25mm) OD stainless steel handle 0.30” (7.6) thick covered with a plastic sleeve that is coated with a heat adhesive be…

2007/04/03

Objective Debond a fluorocarbon rubber seal from a carbon steel oil seal Material 4” (10.2cm) OD carbon steel oil seal with a fluorocarbon rubber sealTemperature 1200 F (649 C)Frequency 179 kHzEquipment • UM-UHF-6kW induction heating system, equipped wit…

2007/04/03

Objective To heat a steel sombrero nut prior to gasket bondingMaterial • Steel sombrero-shaped nut approx. 2” (50.8mm) diameter, 2” (50.8mm) in height • gasketTemperature 350 F (176 C)Frequency 266 kHzEquipment • UM-UHF-6kW induction heating system, e…

2007/04/03

Induction Cap Sealing_2

2012/07/03

Objective Heat steel, stainless steel, nickel chrome rear view mirror brackets and adhesive are to be bonded onto a section of windshield glass. Material Steel, Stainless Steel, and Nickel Chrome rear view mirror brackets measuring 1"(25.4mm) in di

2014/05/22